Skip Navigation

FAQ Search

Replacing the Mid-Range driver in your LSiM Series loudspeaker

How do I replace the Mid-range driver in my LSiM speaker?
To replace the mid-range driver you'd need a number 2 philips screwdriver (Do not use a drill).
 
Procedure
1.    Using your fingers, remove the decorative rubber trim gasket from the face of the tweeter/ mid-woofer assembly. The gasket is friction fitted along the perimeter and adhered with adhesive across its rear surface.
If you cannot remove the gasket with your fingers, you can use a firm plastic edge such as a spatula to pry the gasket out, but be VERY CAREFUL not to mar the cabinet.
 
2.    Using your screwdriver, remove the 4 screws that secure the mid-range driver to the sonic engine assembly.
 
3.    Remove the mid-range driver and using your fingers, or a small pair of needle nose pliers, disconnect the two wires from the terminals of the mid-range driver.
4.    Replace the wires onto the terminals of the new mid-range driver. The positive and negative terminals are different sized FastOn connectors and will only connect to the appropriate terminal of the driver. There is no need to worry about the polarity of the connections.
5.    Carefully install the new mid-range driver back into the assembly and replace the screws. Be sure to tighten the screws completely by hand and do not over tighten.
6.    Replace the decorative gasket by firmly pressing on the surface of the gasket to re-adhere the gasket to the face of the assembly.
7.    If you have any further questions, please feel free to contact Polk Audio Technical Support at 800-377-7655 and selecting option 1 from the main menu.
Your rating has been submitted, please tell us how we can make this answer more useful.

Print